Electrical Lockout/Tagout Procedure; Gas Lockout/Tagout Procedure; Gas Leak Test - Jade JTRH Service Manual

ELECTRICAL LOCKOUT/
TAGOUT PROCEDURE
WARNING
BEFORE PERFORMING ANY SERVICE THAT
INVOLVES ELECTRICAL CONNECTION OR
DISCONNECTION AND/OR EXPOSURE TO
ELECTRICAL COMPONENTS,
PERFORM THE ELECTRICAL LOCKOUT/
TAGOUT PROCEDURE. DISCONNECT ALL
CIRCUITS. FAILURE TO COMPLY CAN CAUSE
PROPERTY DAMAGE, INJURY OR DEATH.
The Electrical LOCKOUT/TAGOUT Procedure is
used to protect personnel working on an electrical
equipment. Before performing any maintenance
or service that requires exposure to electrical
components, follow these steps:
1. In electrical box, place equipment circuit
breaker into OFF position.
2. Place a lock or other equipment on electrical
box cover to prevent someone from placing
circuit breaker ON.
3. Place a tag on electrical box cover to indicate
that equipment has been disconnected for
service and power should not be restored until
tag is removed by maintenance personnel.
4. Disconnect equipment power cord from
electrical outlet.
5. Place a tag on the cord to indicate that
equipment has been disconnected for service
and power should not be restored until tag is
removed by maintenance personnel.
GAS LOCKOUT/TAGOUT
PROCEDURE
WARNING
BEFORE PERFORMING ANY SERVICE
THAT INVOLVES GAS CONNECTION OR
DISCONNECTION AND/OR EXPOSURE TO
GAS, ALWAYS FOLLOW THE GAS LOCKOUT/
TAGOUT PROCEDURE. FAILURE TO COMPLY
CAN CAUSE PROPERTY DAMAGE, INJURY
OR DEATH.
SM-10
ALWAYS
REVIEW COPY 7
Titan
Model Series JTRH, JMRH & JTRHE
The Gas LOCKOUT/TAGOUT Procedure is used to
protect personnel working on a gas equipment.
Before performing any maintenance or service that
requires gas disconnections, follow these steps:
1. Locate the gas shutoff valve or inlet.
2. Place the valve in the OFF position.
3. Place a tag on the valve indicating that service
is being performed on equipment and the gas
must remain off until service is complete.
4. Place a locking device on the gas valve or
inlet, preventing connection until the lock is
removed.
5. On the equipment, make sure all flame sources
are extinguished and/or removed.
6. Bleed residual gas from the equipment inlet
line and allow time for the gas to dissipate
before beginning service on the equipment.

Gas Leak Test

WARNING
ALL GAS JOINTS DISTURBED DURING
SERVICE MUST BE CHECKED FOR LEAKS.
DO NOT USE AN OPEN FLAME. USE A
HAZARDOUS GAS TESTER OR A SOAP AND
WATER SOLUTION. BUBBLES INDICATE A
GAS LEAK. FAILURE TO COMPLY CAN CAUSE
PROPERTY DAMAGE, INJURY OR DEATH.
WARNING
IF A GAS LEAK IS DETECTED, DO NOT
OPERATE THIS OR ANY OTHER EQUIPMENT
UNTIL THE LEAK HAS BEEN PROPERLY
REPAIRED. FAILURE TO COMPLY CAN CAUSE
PROPERTY DAMAGE, INJURY OR DEATH.
After completing service on any gas equipment,
all gas joints disturbed during service must be
checked for leaks. DO NOT USE AN OPEN
FLAME. Use a hazardous gas tester or use a soap
and water solution as follows:
1. Apply a soap and water solution to gas joint
and check for bubbles.
2. If bubbles are present, the joint is leaking and
must be repaired before using the equipment.
Jade Range LLC – A Middleby Company
TM Series Heavy Duty Range