Installing The Keyboard And Mouse Set; Getting The Receiver Ready - Memorex RF6000 User Manual

3. Installing the Keyboard and Mouse Set

This wireless keyboard and mouse combo consists of a receiver that plugs
into the computer, a wireless keyboard, a wireless mouse, and a
Mouseport™ charging station.

3.1 Getting the Receiver Ready

Connect the receiver and select a wireless channel:
1. Make sure your PC is switched off.
2. Turn the receiver over and find the channel slide switch. Select either
channel CH1 or CH2. Remember which channel you selected.
Bottom View of Receiver
3. Connect the receiver to your PC: Plug the receiver's green PS/2 connector
into the mouse port of your computer. Plug the receiver's purple PS/2
connector into the keyboard port of your computer.
4. Set the receiver flat on a surface and follow these guidelines:
a. There should be a minimum of 8 inches clearance between the receiver
and other electronic devices.
b. There should be a minimum of 8 inches clearance between the receiver
and the monitor.
c. The mouse and keyboard can operate at a range of up to 6 feet.
d. For better reception, the receiver works best on a nonmetallic surface.
3
Slide Switch Setting of Receiver