Panasonic Lumix DMC-GH4A Basic Operating Instructions Manual page 97

[This battery cannot be used]
•
Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or Panasonic.
•
If the battery terminal is dirty, clean it and remove any objects.
[Failed to connect wireless access point]/[Connection failed]/[No destination
found]
•
Check following regarding the wireless access point.
–
The wireless access point information set on this unit is wrong.
Check the authentication type, encryption type, and encryption key.
–
Power of the wireless access point is not turned on.
–
Setting of the wireless access point is not supported by this unit.
•
Check the network setting of the destination.
•
Radio waves from other devices may block the connection to a wireless access point.
Check other devices that are connected to the wireless access point and devices that use the
2.4 GHz band.
[No picture to send]
•
This is displayed when there is no image to transmit due to the restriction of the destination.
Check the file format of the image to send.
[Connection failed. Please retry in a few minutes.]/[Network disconnected. Transfer
stopped.]
•
Radio waves from the wireless access point are getting weak.
Perform the connection closer to the wireless access point.
•
There is no reply from the server or it has exceeded the communication processing time.
Try again after a while.
•
Depending on the wireless access point, connection may be automatically disconnected after
specific time has passed.
Reconnect the connection again.
[Connection failed]
•
Check following regarding the smartphones/tablet you intend to connect.
–
The smartphone/tablet does not operate.
–
Change the access point to connect to in the smartphone/tablet Wi-Fi settings to this
camera.
–
There is no free storage space on the smartphone/tablet.
Others
97
(ENG) VQT5H93