Preparation; Care Of This Camera - Panasonic Lumix DMC-GH4A Basic Operating Instructions Manual

Preparation

Care of this Camera

To avoid damaging your camera and to experience the maximum enjoyment you
should exercise the following precautions.
•
The lens, monitor and the camera body can sustain damage if the camera body is dropped or
subjected to excessive temperature, moisture, water or dust.
•
The monitor can be damaged if excessive pressure is applied to the screen surface, during
actual use or while cleaning.
∫ Splash Proof
Splash Proof is a term used to describe an extra level of protection this camera offers
against exposure to a minimal amount of moisture, water or dust. Splash Proof does not
guarantee that damage will not occur if this camera is subjected to direct contact with
water.
In order to minimise the possibility of damage please be sure the following precautions are
taken:
–
The Splash Proof feature works in conjunction with the H-HS12035 and H-HS35100 lenses
that were specifically designed to support this feature.
–
Make sure the built-in flash is closed.
–
Make sure that all doors, socket caps and terminal covers are securely closed.
–
Make sure that you are in a dry and secure place when changing the battery, lens or memory
card. After changing, make sure their protective doors are securely closed.
–
If this camera is exposed to water, sand or any other foreign material clean it as soon as
possible, taking the necessary precautions that the foreign substance does not get inside the
camera.
–
Under no circumstances should you touch or place any foreign objects within the camera or
in close proximity of the camera's image sensor.
∫ Condensation
•
Condensation may occur on the lens, monitor or in the viewfinder when the room temperature
or humidity changes rapidly. This may cause the image to temporarily become hazy. If this
occurs, turn the camera off and allow the camera to sit in a temperature stable environment for
several minutes. It will clear by itself.
•
If you know that you will be moving between areas where there will be a large change in
temperature or humidity, you can help prevent condensation forming on the camera by placing
the camera in a large plastic zipper bag, so condensation will form on the bag, not the camera.
Allow the temperature to stabilise before removing the camera from the bag.
8
VQT5H93 (ENG)