Samsung MH020FVEA Service Manual page 50

✳ Setting is not required if you must
a value which has a
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode Selection key,
The display part shows
Press the Mode Selection key,
The display part shows
Step 4 : Pressing the ON/OFF button (
When pressing the operation ON/OFF key with the direction of remote control for unit, the sound ''Ding'' or ''Diriring'' is
heard and the OPERATION ICON(
completed. (If the diriring sound isn't heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote control.
Second, Re-insert the battery into the remote control.
Third, Press ON/OFF key with the direction of remote control for set.
• Error Mode
1 st If all lamps of indoor unit are flickering, Plug out, plug in power plug again and press ON/OFF key to retry.
2 nd If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the correct option code
is set up for its model.
Samsung Electronics
7
Press
8
Push the
Every time you push the button, the display panel reads
7
8
9
9
Push the
Every time you push the button, the display panel reads
10
11
10
Push the
12
Every time you push the button, the display panel reads
11
Push the
Every time you push the button, the display panel reads
12
Push the
Every time you push the button, the display panel reads
default.
to set the display part to
.
to set the display part to
.
)
) lamp of the display is flickering at the same time, then the input of option is
button, then the default value is
button to set the display panel to
. . .
button to set the display panel to
. . .
button to set the display panel to
. . .
button to set the display panel to
. . .
button to set the display panel to
. . .
and check the display part.
and check the display part.
Alignment and Adjustments
.
.
repeatedly.
.
repeatedly.
.
repeatedly.
.
repeatedly.
.
repeatedly.
3-11