The tool should be connected only to a power supply of EC Declaration of Conformity the same voltage as indicated on the nameplate, and Makita declares that the following Machine(s): can only be operated on single-phase AC supply. They Designation of Machine:...
Yasushi Fukaya recommended. Director Personal safety Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium Stay alert, watch what you are doing and use common sense when operating a power tool. Do GEA005-3 not use a power tool while you are tired or under General Power Tool Safety Warnings the influence of drugs, alcohol or medication.
21. Store idle power tools out of the reach of Be sure that there are no cracks or breakage children and do not allow persons unfamiliar on the pad before use. Cracks or breakage with the power tool or these instructions to may cause a personal injury.
FUNCTIONAL DESCRIPTION ASSEMBLY CAUTION: CAUTION: Always be sure that the tool is switched off and Always be sure that the tool is switched off and • • unplugged before adjusting or checking function on unplugged before carrying out any work on the the tool.
Page 6
While pulling abrasive paper to maintain the proper Dust bag (optional accessory) tension, insert and secure the other end of abrasive 1. Dust spout paper between another clamper and the pad and return 2. Dust bag the paper clamp lever to the original position. Place the punch plate (optional accessory) over the paper so that the guide of the punch plate is flush with the sides of the base.
If you need any assistance for more details regarding cardboard lip, then by pulling the cardboard lip these accessories, ask your local Makita Service Center. downwards to move it out of the holding tab of the dust Abrasive paper (with pre-punched holes) •...