Dixon 5000 Series Operator's Manual page 12

CHASSIS:
BODY:
SEAT:
MOWER DECK:
BLADE DRIVE:
DRIVE SYSTEM:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
NOTE:
SPECIFICATIONS
Model ZTR 5601
11 GA - rectangular tube
Two piece - made of rotational molded polyethylene. Front body contains
access panels for battery service and engine to mower deck belt removal. Rear
body tilts up to allow service on the entire drive system.
Economically designed for operator comfort by use of high density closed cell
foam, contoured back rest and arm rests. Seat is adjustable fore and aft.
11 GA stamped steel construction
3 blades combine for 60" cut width Cut height approximately
1" to 4" via 8 position lift handle
Electric clutch
Each rear wheel is independently driven by a Hydro-Gear BDU-10L Series 70
hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
enclosed Hydro-Gear gearbox.
22 HP Kohler Command, 4 -Cycle, Twin Cylinder, V -Configuration, Overhead
Valve, Air-Cooled, Gasoline, Vertical Shaft, Aluminum Head and Crankcase with
Cast Iron Liners, Oil Cooler.
Electric by key switch operation with safety interlocks on parking brake and blade
drive clutch.
Front 1 1 X 4 X 5 ribbed tread
Rear 20 X 10 X 8 turf savers
Front 16-21lbs.
Rear 8-14lbs.
Fuel - 4.8 gallons total (dual tanks)
Hydrostat oil tank - 3 quart with in-line 10 micron filter
Hydrostat oil recommendation, refer to page 40 Engine - 2
qts. SAE 10W30 (with filter)
Width 72"
Height 45"
Length 72"
Weight 685 Ibs.
Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE