Setting Up - JVC MP-XP5230GB Instructions Manual

16
EN

SETTING UP

When you first use your Mobile PC, always plug the AC power cord into the DC Input connector.
The built-in lithium-ion battery pack will be recharged during your PC setup. To avoid data loss
due to power failure or any others cause, check the points for battery recharging in Page 18.
1. Unplug the jumper pin before recharging the battery pack
Always unplug the battery terminal jumper pin from the PC rear panel when recharging the
battery pack by plugging the AC power cord into the DC Input connector.
Battery terminal jumper pin
Unplug the jumper pin
using the tip of a ball point
pen or similar.
The jumper pin is factory-mounted to
(
disconnect the battery pack from the
circuitry. The removed pin is not used again.
2. Mounting/Dismounting the Lithium Ion Battery Pack
¡ Mounting Battery Pack
1 Slide lock lever A in the direction of the
arrow (outward).
2 Mount and lock the battery pack until it
clicks.
3 Slide lock lever A in the direction of the
arrow (inward).
4 Tighten two coin screws (when the large
capacity lithium ion battery pack is used).
Tips
Cover the battery terminal with the protection cover of
accessory kit if you use the Mobile PC without using the
standard lithium ion battery pack or the optional large
capacity lithium ion battery pack.
1
Jumper pin
)
b N
Lock lever A
¡ Dismounting Battery Pack
Holes for mounting
optional large-capacity
lithium ion battery pack
1 Slide lock lever A in the direction of the arrow.
2 Slide and hold lock lever B in the direction of the
arrow, and pull out and dismount the battery pack
in direction 3 as shown.
Mounting the Protection Cover
1 Slide lock lever A mounted at
2
the bottom of the Mobile PC
in the direction of the arrow.
3
2 Mount the battery terminal
protection cover.
3 Slide lock lever A in the
direction of the arrow until it
locks.
o [A
SETTING UP