Hitachi CP-X8150 User Manual page 66

OPTION menu
Item
DIRECT POWER
ON
AUTO POWER
OFF
SHADE TIMER
(continued on next page)
66
Using the ▲/▼ buttons turns on/off the DIRECT POWER ON
function.
ON OFF
When set to the ON, the lamp in projector will be automatically turned
on without the usual procedure (
supplied with the power after the power was cut while the lamp was on.
• This function does not work as long as the power has been
supplied to the projector while the lamp is off.
• After turning the lamp on by the DIRECT POWER ON function,
if neither input nor operation is detected for about 30 minutes, the
projector is turned off, even though the AUTO POWER OFF function
below) is disabled.
(
Using the ▲/▼ buttons adjusts the time to count down to
automatically turn the projector off.
Long (max. 99 minutes)
When the time is set to 0, the projector is not turned off
automatically.
When the time is set to 1 to 99, and when the passed time with
no-signal or an unsuitable signal reaches at the set time, the
projector lamp will be turned off.
If one of the projector's buttons or the remote control buttons
is pressed or one of the commands (except get commands) is
transmitted to the CONTROL port during the corresponding time,
projector will not be turned off.
Please refer to the section Turning off the power (
Using the ▲/▼ buttons sets the time from closing the lens shade to
automatically turning the projector off.
1h 3h 6h
• The shade will open automatically when turning the projector on
again.
Description
24), only when the projector is
Short (min. 0 minute = DISABLE)
24).