Advertisement
Mounting the Unit on the bracket
1.
Line up the unit with the mounting bracket and snap it into place.
2.
Push the unit forward or backward to adjust the viewing angle.
Suction Cup Transducer Assembly
1.
Place a washer on each side of the
transducer mount and slide it into the
transducer bracket.
2.
Align the washers with the holes in
the transducer mount and transducer
bracket.
3.
Insert the bolt through the hole in the
transducer bracket.
4.
Slide the remaining washer over the end of the bolt and screw on
the nut.
5.
Screw the suction cup onto the bracket
using the supplied screw and flat washer.
6.
Tie the nylon cord through the hole in the top
of the bracket. When using the transducer,
tie the other end of the nylon cord to the
boat. That will prevent you from losing the
transducer if the suction cup comes loose.
7.
Clean the portion of the hull where the suction cup will be attached.
3
Washers
Advertisement
