Table of Contents
Advertisement
NOTE
1.
When installing the Clamper Magnet, install it with the
green face up.
2.
When installing the wire of the Lever Switch, install it
correctly as Fig. 3-4-B.
3.
When installing the Lever Switch, install it correctly as
Fig. 3-4-C.
4.
In case of the Lever Switch installation, hook the wire on
the Main Frame as shown Fig. 3-4-D.
Lever Switch
Rack Loading
3-5: TRAVERSE HOLDER/INSULATOR (F)
(Refer to Fig. 3-5-A)
1.
Remove the Traverse Holder.
2.
Remove the 2 Insulator (F).
Main Chassis Ass'y
Insulator (F)
(Black)
Traverse Holder
NOTE
1. After the installing of the Traverse Holder, check if the
wire is like Fig. 3-5-B.
DISASSEMBLY INSTRUCTIONS
Red
White
From DVD PCB
Blue
Fig. 3-4-B
The Lever should be position
between A and B.
A
B
Fig. 3-4-C
Lever Switch
Fig. 3-4-D
Insulator (F)
(Black)
Fig. 3-5-A
3-6: SWITCH PCB ASS'Y (Refer to Fig. 3-6-A)
Remove the screw 1.
1.
2.
Remove the Switch PCB Ass'y.
Switch PCB Ass'y
Main Chassis Ass'y
• Screw Torque: 4 ± 0.5kgf•cm
NOTE
1. When installing the wire of the Switch PCB, install it
correctly as Fig. 3-6-B.
Switch PCB Ass'y
3-7: RACK FEED ASS'Y (Refer to Fig. 3-7-A)
Remove the screw 1.
1.
2.
Remove the Rack Feed 1/2 Spring, Rack Feed 1/2 and
Rack Feed Lever.
Rack Feed 1 Spring
Rack Feed 2 Spring
Rack Feed Lever
Rack Feed 1
• Screw Torque: 3.5 ± 0.5kgf•cm
B3-2
Main Chassis Ass'y
Traverse Holder
1
Black
From Relay PCB
White
1
Rack Feed 2
Main Chassis Ass'y
Fig. 3-5-B
Fig. 3-6-A
Fig. 3-6-B
Fig. 3-7-A
Advertisement
Table of Contents
