BRP 2995 Johnson Service Manual page 36

Thread the throttle cable connector onto the cable
end.
Turn throttle drum fully counter clockwise .
While pushing cable end in, adjust the connector
until the center of connector hole aligns with the
center of outer ball pivot on the drum.
When aligned, press fit the connector onto the
outer ball pivot and tighten the lock nut.
IMPORTANT: Install the connector of throttle
control cable onto the OUTER ball pivot on the
drum.
1. Throttle cable connector
2. Throttle drum
3. Lock nut
@
CD
004818
Make sure throttle drum contacts stop with throttle
control fully opened. Also, make sure 0 to 2 mm
clearance exists between the carburetor throttle
INSTALLATION AND PREDELIVERY
OUTBOARD RIGGING
lever and stop with throttle control fully opened . If
not, adjust connector.
1. Throttle stop
32276
2. Carburetor throttle lever
3. Carburetor throttle stop
4. Clearance
Shift Cable Installation
Secure shift cable in cable holder by fitting groove
on the cable into slot on the holder.
1. Shift cable
004820
2. Cable holder
Make sure that the clutch control arm is in the
NEUTRAL position .
Thread the clutch cable connector onto the cable
end until the connector aligns with thread hole of
37
I
E
o
U
Qj
)(
~
Qj
~
ii
E