Table of Contents
Advertisement
MAINTENANCE
WARNING: For your safety, before performing any maintenance on the drill turn
OFF the power switch and UNPLUG the power cord.
1.
General Rules
A. Always clean the machine before performing any maintenance/repair.
B. A clean machine makes visual inspection for problems easier to notice.
2.
Steps to Follow When Cleaning
A. Please do not use aggressive cleaners (i.e. containing solvents). Do not use
high-pressure water jets, aggressive detergents or solutions and liquids with a
temperature exceeding 86ºF! Use a fluff-free cloth only.
B. For the sake of safety, no water/cleaning liquid/vapor may penetrate into the
electric motor, connectors/plugs, switches, etc. Cover all apertures, holes in the
housing, connectors or plugs, etc. or seal them with adhesive tape!
C. Use a cloth which may be lightly moistened only for removing dust and dirt.
Hard packed dirt can be removed with a soft brush.
D. After cleaning, remove all covers and adhesive tape! All screws/nuts which
you may have loosened must be tightened again! After wet cleaning, try the
machine on a power outlet which is equipped with a power breaker (i.e. fault
current circuit breaker). If the fault current circuit breaker cuts the power supply,
the machine must be inspected by an authorized dealer prior to use!
12
Advertisement
Table of Contents
