Operating External Components With The Remote Control; Operating The Tv - JVC GVT0154-001A Instructions Manual

Operating external components with the remote control

The buttons described below are used on pages 12 and
13.
TV/VIDEO
REC
TV RETURN
NOTE
• Manufacturers' codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.

Operating the TV

7 To set the manufacturer's code
You can operate a JVC TV without setting the manufacturer's code.
1
Slide the remote control mode selector
to TV.
2
Press and hold
Keep the button pressed until step 4 is finished.
3
Press ENTER.
TV VCR/DBS
VCR/DBS
VCR DBS
DBS
VCR
Remote control
TV
mode selector
VCR/DBS
(play button)
ENTER
Number
buttons
100+
TV.
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV:
Press 1, then 0.
For a Toshiba TV:
Press 0, then 8.
Manufacturer Code
JVC 01
Hitachi 10
Magnavox 02
Mitsubishi 03
Panasonic 04, 11
RCA 05
5
Release TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7 Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons are available:
Turns TV on and off.
TV:
Adjusts the volume.
TV VOL +/–:
Selects the input mode (either TV or
TV/VIDEO:
VIDEO).
Changes the channels.
CHANNEL +/–:
1-10, 0, +10 (100+): Selects the channel.
Alternates between the previously selected
TV RETURN:
channel and the current channel.
Manufacturer Code
Samsung 12
Sharp 06
Sony 07
Toshiba 08
Zenith 09
12