Advertisement
SET UP
Lower the motor to the required depth, making sure that it locks into the vertical position
securely.
DEPTH ADJUSTMENT
Hold the motor shaft with one hand, loosen the depth adjustment screw and set the
motor to the desired depth. Then retighten the adjusting screw securely.
STOWING
When the Watersnake is not in use always stow it properly. Pull the stow release cord and
raise the motor until it is secure on the ramp and locked in the horizontal position out of
the water.
FOOT PEDAL CONTROL SYSTEM
The low profi le foot pedal control is used to adjust direction and speed. A speed control
lever is located at the right side of the foot control box(1). Steering is enabled via the
large pedal. Pushing down at the top left hand corner of the pedal with your foot will
turn the motor to the left (2); to steer to the right push your foot down at the top right
hand corner of the pedal (3). Use your heel at the bottom of the pedal to pause or
resume thrust (power)(4). A constant on/off switch is set at the left hand side of the foot
pedal control box.(5)
Foot pedal
control system
CHANGING THE PROPELLOR
Before doing anything with the propeller, ensure the cables to the battery are
disconnected.
To detach the propeller it is a simple matter of unscrewing and removing
the locknut using the special tool supplied. When doing this, take hold of the propeller to
stop it turning. Under no circumstances should you attempt to loosen the locknut with a
hammer or similar tool as this may damage the locknut or shaft – or both. (F)
(2)
(5)
(4)
(3)
(1)
Advertisement
