Alarm Functions; Adjusting The Alarm Time; 1St Alarm (Alarm1); 2Nd Alarm (Alarm2) - inStudio Prescott Instruction Manual

This unit allows you to set two different wake up times with the ALARM 1 and ALARM 2 buttons .

ADJUSTING THE ALARM TIME

1st Alarm (ALARM 1)
1 . Press the STANDBY/ON button once to turn off the device .
2. Press the ALARM 1 button once. The LED ALARM1 lights up and 0:00 flashes on the display.
3 . Then press the >>I / HOUR button to adjust hour (1-24) .
4. Afterwards, press the I<< / MINUTE button to adjust minutes.
5. To conclude, press the ALARM 1 button again.
2nd Alarm (ALARM 2)
1 . Press the STANDBY/ON button once to turn off the device .
2. Press the ALARM 2 button once. The LED ALARM2 lights up and and 0:00 flashes on the display.
3 . Then press the >>I / HOUR button to adjust hour (1-24) .
4. Afterwards, press the I<< / MINUTE button to adjust minutes.
5. To conclude, press the ALARM 2 button again.

Wake to Buzzer

Select with the function selector BUZZER/AM/FM/CD the option BUZZER after wake up time is set .

Wake to Radio

1 . Follow procedures under Radio to select your desired radio station .
2 . Press the STANDBY/ON button once to turn off the device .
3 . Select the desired radio frequency band AM or FM with the function selector BUZZER/AM/FM/CD .
4 . Set desired volume .
5 . Follow procedures under Adjusting the Alarm Time to set the wake up time .

Wake to CD Music

1 Follow procedures under CD .
2 . Press the STANDBY/ON button once to turn off the device .
3 . Select with the function selector BUZZER/AM/FM/CD the option CD .
4 . Set desired volume .
5 . Follow procedures under Adjusting the Alarm Time to set the wake up time .
Note:
If the alarm sound is not stopped manually by the button SNOOZE or STANDBY/ON the system will turn off
the alarm sound after 60 minutes .

Stopping the Alarm

The alarm is programmed to run for 60 minutes .
1. Press the SNOOZE button to stop the alarm temporarily, the alarm will stop and ring again automatically
after 6 minutes .
2. Press the STANDBY/ON button to stop the alarm temporarily, the alarm will sound again 24 hours later.
3. To turn off the alarm permanently, press the ALARM 1 or ALARM 2 button, the alarm LED indicators will
turn off .

Sleep Mode

1 . Select your desired mode to be used by the sleep function .
2. Press SLEEP button, the LED SLEEP lights up und the device will go to the sleep mode.
3 . Press SLEEP button again to select the desired sleep time (4 possibilities: 90 - 60 - 30 - 15 minutes) .
4. Turn off the sleep function by pressing SLEEP, until the LED indicator SLEEP turns off.

Alarm Functions

6