Related Manuals for Movincool CM 25
Summary of Contents for Movincool CM 25
- Page 1 INSTALLATION MANUAL CONDENSATE PUMP KIT (Part No. GX484789-0180) FOR CM 25 Production Period: From October 2009 (1009) READ THIS MANUAL CAREFULLY FOR INSTRUCTIONS ON CORRECT INSTALLATION AND USAGE, AND READ ALL SAFEGUARDS.
- Page 2 All rights reserved. This book may not be reproduced or copied, in whole or in part, without the written permission of the publisher. DENSO SALES CALIFORNIA, INC. reserves the right to make changes without prior notice. MovinCool is a registered trademark of DENSO Corporation.
-
Page 3: Condensate Pump Kit
INSTALLATION MANUAL CONDENSATE PUMP KIT FOR CM 25... -
Page 4: Definition Of Terms
Protect the power cable from coming in contact with sharp objects. • Do not kink or allow power cord to come in contact with oil, grease, chemicals, or hot surfaces. • To reduce risk of electrical shock, connect MovinCool unit to a prop- erly grounded terminal. - Page 5 Drain Inlet Hose (1) Cover Plate (1) Clamp (1) Grommet (1) L10 Screws (2) L16 Screw (1) Note: If any of these items are not included in the box or appear damaged, please contact your MovinCool reseller for replacement .
-
Page 6: Pump Installation
PUMP INSTALLATION 1. Remove tab from pump. 2. Disconnect the power from CM25. ! WARNING: Make sure CM25 circuit breaker is in the “OFF” position. 3. Remove the four screws from the front left panel of the unit. 4. Install the adapter plate with the three screws which were previously removed. - Page 7 PUMP INSTALLATION (cont.) 5. Remove the cover plate by removing the two screws. 6. Remove the jumper plug from mating connector. Note: Keep the jumper plug for future application. 7. Mount the condensate pump assembly to the adapter plate with the two L10 screws supplied in the kit.
-
Page 8: Hose Installation
PUMP INSTALLATION (cont.) 9. Attach the grommet and cover plate to the adapter harness. 10. Install the cover plate with two screws which were previously removed in step 5. HOSE INSTALLATION 1. Plug in one end of the drain inlet hose with the supplied clamp into the drain pipe of the unit. - Page 9 HOSE INSTALLATION (cont.) 3. Plug in the supplied 20 feet (6 m) drain outlet hose into the drain outlet spout of the condensate pump. Note: Insulate the drain outlet hose to prevent condensation if necessary. 4. Check the drainage performance after installation.
-
Page 10: Inspection And Maintenance
INSPECTION & MAINTENANCE ! WARNING: When performing any maintenance and/or troubleshooting, make sure that all electrical power is off. This means before service, unplug the unit from the electrical outlet or if permanently wired, make sure the circuit breaker is in the off position. 1) Remove any dirt or debris which may collect in the bottom of the reservoir tank. -
Page 11: Troubleshooting
TROUBLESHOOTING Check the following items before calling your MovinCool reseller or a qualified technician. Self- Remedy Diagnostic Codes Buzzer Possible Cause (Wall Pattern Wall Mounted Millivolt Wall mounted Controller Thermostat controller) Drain hose clogged Check drain hose for Check drain hose for... - Page 12 DENSO SALES CALIFORNIA, INC. Long Beach CA, 90810 www.movincool.com P/N: 484007-3250EN First Issue: December 2009...
Need help?
Do you have a question about the CM 25 and is the answer not in the manual?
Questions and answers