Satellite Information - Raymarine 33STV User Manual

Satellite information

Important: We recommend that you do NOT attempt to edit
satellite information. However, if you have to do so, contact the
Raymarine Customer Support Department for advice before
making any changes.
The editable parameters are typically, in sequence:
• LONGITUDE in degrees and minutes, plus E/W selector.
• VER LOW/RHCP. Vertical low band tracking frequency (in MHz)
and symbol rate (in kHz).
• VER LOW NID. Vertical low band network identity (NID).
• HOR LOW/LHCP. Horizontal low band tracking frequency (in
MHz) and symbol rate (in kHz).
• HOR LOW NID. Horizontal low band network identity (NID).
• VER HIGH. Vertical high band tracking frequency (in MHz) and
symbol rate (in kHz).
• VER HIGH NID. Vertical high band network identity (NID).
• HOR HIGH. Horizontal high band tracking frequency (in MHz)
and symbol rate (in kHz).
• HOR HIGH NID. Horizontal high band network identity (NID).
• The method of verifying satellite tracking. The options are:
– SIGNAL - use only the signal level for tracking.
– DVB LOCK - use only DVB Lock signal for tracking.
– DVB DECODE - verify signal using DVB decoding method for
tracking.
– DSS DECODE - decode only DSS Lock signal for tracking.
• The method of supplying power to the LNB. The options are:
– AUTO - change voltage to LNB by the IRD voltage. This is the
RECOMMENDED SETTING.
32
– ONLY 13 V - always supply 13 V to LNB.
– ONLY 18 V - always supply 18 V to LNB.
• The required method of Digital Satellite Equipment Control
(DiSEqC). The options are:
– AUTO - change signal to LNB by the IRD DiSEqC. This is the
RECOMMENDED SETTING.
– ONLY 0 KHZ - always supply 0 kHz to LNB.
– ONLY 22KHZ - always supply 22 kHz to LNB.
Editing satellite information
To edit satellite information, start with normal operating information
displayed on the ACU, then at the ACU:
1. Carry out the Enter setup mode procedure to display the SET
SAT PAIR? screen.
2. Press the NEXT soft key twice to display the EDIT SAT INFO?
screen.
3. Press YES to enter the edit mode.
A satellite name edit screen is displayed.
4. Use the PREV or NEXT soft key to scroll to the name of the
satellite you want to change.
5. To edit the displayed satellite name, press the SELECT soft key.
An edit screen is displayed.
6. Change the displayed name as follows:
i. Use the + and - soft keys to change the value of the character
above the cursor (underscore).
ii. Press the INPUT soft key to accept each correct character
and move the cursor to the next character.
iii. Repeat sub-steps a, b and c until the correct name has been
entered.
7. Press the ENTER soft key to confirm the edited data and display
the edit screen for the next parameter.
33STV Satellite TV User's Guide