Mitsubishi Electric MSH-18RV Service Manual page 74

OPERATING PROCEDURE
3. Removing the electrical box
(1) Remove the front panel. (Refer to 1)
(2) Remove the electrical cover. (Refer to 2)
(3) Disconnect the connector of the indoor coil thermistor.
(4) Disconnect the motor connector (CN211 and CN121) and
the vane motor connector (CN151) on the electronic
control P.C. board.
(5) Remove the screw of ground wire.
(6) Remove the fan motor lead wire and indoor coil thermistor
from the electrical box.
(7) Remove the lead wire of vane motor from the bottom of
electrical box.
(8) Remove the screw fixing the electrical box, remove the
electrical box.
4. Removing the vane motor
(1) Remove the front panel. (Refer to 1)
(2) Remove the electrical cover. (Refer to 2)
(3) Remove the lead wire of vane motor.(Refer to 3)
(4) Remove the R.L. holder.
(5) Pull out the drain hose from the nozzle assembly, remove
the nozzle assembly.
(6) Remove the screws of the vane motor, disconnect the con-
nector.
(7) Remove the vane motor.
Photo 5
Screw of the
vane motor
Vane motor
5. Removing the line flow fan and the indoor fan motor
(1) Remove the front panel. (Refer to 1)
(2) Remove the electrical box. (Refer to 3)
(3) Pull out the drain hose from the nozzle assembly, remove
the nozzle assembly.
(4) Remove the water cut.
(5) Slide the hole cover, remove the hole cover.
(6) Remove the hexagon socket set screw from the line flow
fan.
(7) Remove the screws fixing the fan motor, remove the fan
motor. (Be careful not to drop the fan motor because it is
heavy.)
(8) Remove the screws fixing the left side of the heat
exchanger.
(9) Lifting the left side of the heat exchanger.
(10) Remove the line flow fan.
Photo 8
Hole
cover
Photo 3
Photo 4
Vane motors
Photo 6
Screws fix-
ing the left
side of the
heat
exchanger
Photo 7
Indoor
coil
thermistor
Water cut
Screws fixing the fan motor
74
PHOTOS
Screws of the ground wire
Screw of the
electrical cover
Screw of the
electrical box
Screws
of the
vane
motor