Table of Contents
Advertisement
8.1. Grinder set up
Place the hopper (
is in the closed position. Lock the hopper (
to gently tighten the hopper security screw making it match to the hole at the bean
hopper collar (
Remove the hopper lid (
hopper (
) (Fig. 2).
Plug in the grinder, and place the main power switch (
the bean trap (
ADVANCED
model, place the main power switch (
place the mode switch (
In the PUSH / TOUCH models, the power switch I-0-II is situated on the right side
and on the TOUCH ADVANCED the main power switch is situated on the right side
while the MODE switch is on the left hand side
K01070 | v. 22/09/2014 | Ref. quality process 002/03 | ORIGINAL INSTRUCTIONS
) on the grind regulator (
) (Fig. 1).
), fill the Hopper with coffee (
) to allow coffee to pass into the grind chamber. In the
) on mode MANUAL (M).
8. REGULATION
) and make sure the bean trap (
) in place using a flat head screw driver
), and replace the lid on the
or
) to position I and open
) ON-OFF in position ON and
)
TOUCH
9
Advertisement
Table of Contents
