Using A Mulching Mower - Simplicity Regent Series Operator's Manual

Operation

USING A MULCHING MOWER

Benefits of Proper Mulching
Mulching consists of a mower deck which cuts and
recuts clippings into tiny particles and then blows them
down into the lawn. These tiny particles decompose
rapidly into by-products that your lawn can use. Under
proper conditions your mulching mower virtually elimi-
nate noticeable clippings on the lawn surface.
Limitations of Mulching Decks
Mulching mowers cannot function properly if the grass is
wet, or if the grass is simply too high. Even more than
normal mowing, mulching requires that the grass be dry
and no more than 1/3 of the height is cut.
Do not use the mower as a mulching mower during the
first two or three cuttings in the spring. The long grass
blades, quick growth, and often wetter conditions are
more suitable for broadcasting (side-discharging).
Correct Ground Speed & Engine Speed
Use full engine throttle to maximize mower blade tip
speed matched with a slow ground speed so that clip-
pings will be finely cut. Ground speed while mulching
should be half the speed used when broadcasting (side-
discharging) under similar conditions. Since mulching
requires more horse power that broadcasting, using a
slower ground speed is vitally important for proper
mulching operation.
Correct Cutting Height
Cutting off too much at one time shocks the plants
growth system and weakens the grass plants. A good
rule of thumb is the 1/3 rule: to cut no more than one
third of the grass height, and never more than 1 inch at a
time.
The best mulching action typically results from cutting
only the top 1/2" to 3/4" of the grass blade. This provides
short clippings which decompose properly (much more
quickly than longer clippings). The ideal cutting height
will vary with climate, time of year, and quality of your
lawn. We recommend that you experiment with both the
cutting height and ground speed to achieve the best cut.
Start with a high cutting height and use progressively
lower heights until you find a cutting height that is
matched to your mowing conditions and preferences. For
best results, overlapping is recommended.
A
Figure 3. Installing the Side Discharge Deflector
A. Side Discharge Deflector
B. Mulching Cover
Using the Side Discharge Deflector
When to use the side discharge deflector: If you've
been on vacation or missed a mowing and the grass has
gotten very long, do not try to mulch at your normal cut-
ting height. To handle these situations your mulching
mower is equipped with a side discharge deflector.
Installing the side discharge deflector allows you to
broadcast clippings. Broadcasting, or side-discharging,
disperses fine clippings evenly over the entire lawn.
Many golf courses use this method. Your mower has a
deep dish deck to allow freer circulation of clippings so
they are broadcast evenly over the lawn.
Always operate the engine at full throttle. Use an appro-
priate ground speed for the thickness and height of grass
you are cutting. If you hear the engine slowing down,
you are mowing too fast, use a slower ground speed.
Mow when the grass is 3"-5"long. Do not cut off more
than 1" in a single pass.
WARNING
Never operate the mower deck without either the
discharge chute or mulching deflector in place.
To install the side discharge chute:
1. Lift up the mulching cover (B, Figure 3).
2. Install the side discharge deflector (A) under the
mulching cover. The side discharge deflector hooks
onto the mulching cover hinge rod, and is held in
place by the mulching cover.
3. Release the mulching cover.
12
B