Features, Controls, & Operation; Control Functions - Simplicity Regent Series Operator's Manual

Features & Controls
Please take a moment and
familiarize yourself with the
name, location, and function
of these controls so that you
will better understand the safety
and operating instructions pro-
vided in this manual.

CONTROL FUNCTIONS

The information below briefly describes the function of individual controls. Starting, stopping, driving, and mowing
require the combined use of several controls applied in specific sequences. To learn what combination and sequence
of controls to use for various tasks see the OPERATION section.
Throttle/Choke Control
(Single Lever Models)
The throttle/choke lever controls engine speed and
choke. Move the throttle forward to increase engine
speed and back to decrease engine speed. Always
operate at FULL throttle. Move the control fully forward
(past the detent) to close the choke. Close the choke for
cold starting. Open the choke once the engine starts. A
warm engine may not require choking.
Throttle Control
(Twin Lever Models)
The throttle controls engine speed. Move the throttle for-
ward to increase engine speed and back to decrease
engine speed. Always operate at FULL throttle.
Choke
(Twin Lever Models)
Close the choke for cold starting. Open the choke once
the engine starts. A warm engine may not require chok-
ing. Move the lever forward to close the choke.
Trans. Release
Lever on Rear
Of Tractor
Headlights
The light switch turns the tractor headlights on and off.
PTO Switch
The PTO (Power Take-Off) switch engages and disen-
gages attachments that use the PTO. To engage the
PTO, pull UP on the switch. Push DOWN to disengage.
Note that the operator must be seated firmly in the trac-
tor seat for the PTO to function.
Ignition Switch
The ignition switch starts and stops the engine, it has
three positions:
OFF
RUN
START
NOTE: Never leave the ignition switch in the RUN posi-
tion with the engine stopped–this drains the battery.
8
Stops the engine and shuts off the
electrical system.
Allows the engine to run and powers the
electrical system.
Cranks the engine for starting.