OPERATING INSTRUCTIONS HARD DISK EXPANSION KORG i2HD/i3HD Table of Contents: Introduction 1. Function "LOAD ONE SONG" 2. Function "LOAD STANDARD MIDI FILE" 3. Function "COPY FILE" 4. Function "NEXT SONG" 5. Function "FORMAT" ©1996 musitronics GmbH...
After selecting the hard disk partition you can use all loading and saving commands as usual. For the normal operational steps please refer to the Player's Guide or the Reference Guide of your KORG i2/i3! The following functions offer new options: 1. LOAD ONE SONG 2.
1. Function "LOAD ONE SONG" Please select "LOAD ONE SONG" on page 2 of DISK mode. After pressing cursor position key A you can choose between the floppy disk drive and hard disk partition by using the VALUE dial or the DOWN/UP keys.
NOTE: Controller, program and note commands of the Standard MIDI File format (GM) are internationally standardized. If you prefer using specific KORG outboard effect processors or the additional Programs in banks C and D as well as the convenient user interface of the song format which is provided on the main page of the sequencer, you can store any Standard MIDI File in the song format of your i2/i3 HD as well.
SMF START After you have pressed the START/STOP key, the user interface of the sequencer appears and the file will be played back automatically. You can stop the music at any point by pressing the START/STOP key again. At the end of the song the display automatically enters DISK mode. EDITING THE SMF IN SEQUENCER MODE After you have selected the song, press the "LOAD"...
4. Function "NEXT SONG" This function can be used to chain together several songs of the same partition in any order and play them back one after another without a break. NOTE: When you create a song chain, the command "Go to song XY" is added to the end of each song (except for the last one).