Set Up; Device Setup Mode - Tesira Tec-1i Operation And Installation Manual

Device Setup Mode

The TEC-1 can be configured without connecting to a functional Tesira network. To enter setup mode,
connect the TEC-1 to a PoE source and place the jumper or any metal object across the locksmith pins.
When configuration is complete, remove the jumper and attach it to only one pin to resume normal
operation. Please note: many of the configuration settings can be accessed via the Tesira software.
The cursor has two modes: select and modify. In select mode, the cursor appears as a gray box. When
scrolling through the available items in the list, the gray box will highlight the current selection.
On fields that can be modified, use the Select button to transition to and from modify mode. In modify mode,
the cursor appears as an outline box. Use the scroll wheel to adjust the setting up or down.
Some screens have additional buttons that are used to accept (OK), reset, or cancel changed settings. Use the
scroll wheel to navigate the cursor to these buttons and press the Select button. The OK button saves the set-
ting and exits the screen. The Reset button clears the setting and does not save it. The Cancel button exits the
screen without saving the setting.
TEC-1 SET UP
Locksmith: Bridge
jumper pins to enter
setup mode
"Select" mode in
device setup menu
"Modify" mode in
device setup menu
6