Assembly And Use For The Disc Attachments - Ninja BL642W Owner's Manual

Assembly and Use for the Disc Attachments

Use caution when handling the discs as the blades are very sharp.
1
2
3
4
5
6
7
8
9
Fig. 5
USING THE DISCS
NOTE: Disc attachments must be used with the
feed chute lid.
IMPORTANT: Use only the High setting when using
either disc.
Place the motor base on a clean, dry, level surface such
as a counter or table top. (Fig. 5)
Secure the bowl onto the motor base.
Place the spindle inside the bowl.
Use the finger holes to grasp the selected disc and
place it over the spindle.
Place the feed chute lid on the bowl and turn clockwise
until you here a click indicating the lid is locked in
place. (Fig. 5)
Plug the power cord into the electrical outlet and press
up on the power toggle ( ) to turn the power "On".
Select HIGH on the control panel. The discs will begin
spinning.
Add the food that you want to slice, shred or grate
through the feed chute on the lid. (Fig. 5) Use the
two-part food pusher to help guide the food through
the feed chute. The middle piece of the food pusher is
removable to use for smaller ingredients.
When finished,stop the appliance by pressing the power
button ( ) and wait for the disc to stop turning. Press
the button on the feed chute lid located near the handle
to unlock and turn the lid counter-clockwise. Lift to
remove from the processor bowl. Using the finger holes,
carefully lift the disc out of the bowl and remove the
spindle.
www.ninjakitchen.com 19