B1EP18ZC
CHECKING AND SETTING THE VALVE TIMING
Checks (continued).
NOTE : The index «e» of the dynamic tensioner roller should be centred within the area «d».
Check the correct positioning of the index «e».
If it is not correct, repeat the operation to tension the timing belt (see corresponding operation).
Refitting.
Refit the tool [1] at «a».
Remove the screw (8).
Refit:
- The upper timing cover (11).
- The lower timing cover (10).
- The accessories drive pulley (9).
- The screw (8).
Tightening torque:
- Screw (8) :
Pre-tighten to
Angular tightening
Remove the tool [1].
Engines : 8HY - 8HV
: 3 ± 0.3 m.daN.
: 180° ± 5°.
157
C3