Installation; Operation - G&K RICE CHEF MINI Instruction Manual

1. Remove the rice cooker from its packaging.
2. Place rice cooker on a firm, level, dry surface free from obstructions.
3. Ensure your power point is switched OFF.
4. Plug the rice cooker into an unshared single phase, 10AMP power
point. If you have a CFXB230 60 cup Rice Cooker, please use a
15AMP power point.
5. Allow a well ventilated air gap of no less than 100mm between
appliances.
The G&K Rice Chef Rice cooker performs two functions; Cooking and
Warming. The rice cooker is controlled by an automatic thermal switch. Two
lights at the front of the control panel indicate when the rice cooker is in
cooking mode or warming mode. The cooking function is activated when the
switch is depressed and the cooking light is illuminated. Once cooking is
completed the thermostat automatically activates the warming function. The
cooking light is extinguished and the warming light is illuminated.
• Cooking temperature for Rice Cookers is approximately 103
• Cooking times vary between models, rice variety and quantities used.
• 2.8L Full capacity approximately ?? minutes cooking time.
• 5.6L Full capacity approximately 45 minutes cooking time.
• 10L Full capacity approximately 60 minutes cooking time.
• Maximum Warming Temperature 75
• Minimum Warming Temperature 60
• If warming temperature falls below 60
re-activated. Do not press the switch.
Times and temperature given are guides only.
FOR PUBLIC HEALTH AND SAFETY WE DO NOT RECOMMEND YOU
KEEP RICE ON WARMING FUNCTION FOR EXTENDED PERIODS OF
TIME. DISCARD ANY UNUSED RICE. NEVER STORE RICE ON THE
WARM FUNCTION OVERNIGHT.
DO NOT ATTEMPT TO REHEAT REFRIGERATED COOKED RICE IN THIS
APPLIANCE. THIS WILL RESULT IN PERMANENT DAMAGE TO BOWL &
HEATING ELEMENT. WARRANTY WILL BE VOIDED.
1. Wash the cooking bowl in hot soapy water using a non abrasive
sponge. Dry well inside, outside and base. Set aside.
2. Rinse the burn proof silicone mat and place in the bottom of the
cooking bowl. The use of the silicone mat is optional.
• DO NOT PLACE THE SILICONE MAT ON THE HEATING
ELEMENT.
February 2010 Revision

Installation

Operation

This will result in permanent damage to the appliance.
o
C.
o
C.
o
C, warming will be automatically
o
C.