Digital Zoom And Autofocus/Metering; Recording Start/Stop And Image Capture; Modes - Okii Systems USB Focus Controller User Manual

Controller Functions: Digital Zoom and Autofocus/Metering
If live view is enabled, a short press of the zoom button cycles through 1x/5x/10x digital zoom,
which can be used to aid in focusing. Digital zoom does not work while recording is active.
Holding the zoom button will initiate either the camera's autofocus or metering
if not recording. You may select whether autofocus or metering is used in the Switch Test and
Reversing Knob Direction section of this manual.
Using the camera's autofocus will cause any saved focus points to lose accuracy.
If you must use autofocus, do so before saving any focus points.
Controller Functions: Record Start/Stop and Image Capture
If the camera is in a video capable mode, a short press of the recording button on the controller
will start or stop video recording. The controller is synced to the camera and will display a red
LED the entire time recording is active. Recording can also be started or stopped on the camera
body, and the controller LED will display the appropriate color.
Holding the recording button will initiate an image capture if not recording video. This also
functions if live view is turned off or the camera is in a normal image capture mode. Even if
autofocus is enabled on the lens, it will not engage.
If you want to autofocus prior to capturing an image, be sure to first use the multifunction digital
zoom/autofocus button.
Note: When a still image is being exposed, the controller continually monitors the camera for a
new file to be written to the memory card and disables any other input. If no memory card is
present, the controller will wait the maximum exposure time, which is 30 seconds. It may appear
that the controller is not responding, but it will resume operation once 30 seconds passes. For
this reason it is recommended to always have a memory card inserted when using the image
capture function.
Controller Functions: Modes
The FC1 USB Focus Controller has four multi-function buttons on the right side. The specific
function of these buttons changes according to the mode of the controller. The LED displays one
of three colors depending on the current mode:
Green
Blue
Purple
To change modes, press the top and bottom multi-function buttons at the same time (buttons 6
and 9 as labeled in the Controller Diagram section). The LED will change color when the mode
is switched.
The active mode is saved even if the controller is turned off.
Note: While recording, the LED always displays red, and the multi-function buttons revert to
focus points. When recording stops, the mode automatically reverts to the last one in use prior to
recording start.
Focus points
Settings adjustment
Focus zone selection
8