Connecting Cameras Via A Wireless Connection - Canon Powershot SD430 Digital ELPH Wireless User Manual

4
When the name of the target camera and [Registration completed]
are displayed, press
If the name is already registered, [Already registered] will be displayed.
If you have failed to register, go back to Step 1 and repeat the procedure.

Connecting Cameras via a Wireless Connection

Connect your camera to the registered target camera via wireless.
You must follow the following procedures for both your and the target camera.
1
Slide the mode switch to
(Wireless) Menu
If you press the
playback mode for both cameras simultaneously (within
approximately 30 seconds), the wireless connection will start.
2
After confirming that the name of the target camera
is selected as the [Target Device], select [Connect]
and press the
neously (within approximately 30 seconds).
Wireless connection will start and wireless lamp and
ton will both blink blue. If you press the FUNC./SET button while
the light is blinking, the connection will be canceled.
When the connection has been completed, the camera's wireless lamp and the
ton will remain on (without blinking), and the icon
screen, showing the connection's signal strength.
If a camera name other than the one you would like to connect to is displayed as the tar-
get device, use the
your choice with
Wireless connection is not possible without memory cards inserted in the cameras.
Changing the Wireless Channel
If the channel (useful frequency) is already in use by another device, change the
channel on one of the cameras making the wireless connection to avoid interference
from radio waves. Channel changes on one camera will automatically be reflected on
the other camera.
1
Select [Target Device], confirm that the
name of the target camera is displayed
and press
2
Use the
Press the MENU button to return to Step 1 without changing the channel.
.
(Playback)
[Connect/Disconnect]
button without displaying the Menu in the
(or ) for both cameras simulta-
button to select the [Target Device], and then select the camera of
or button.
.
or button to change the channel and press
but-
will be displayed on the playback
3
but-
.