A-MTK 2M Tiny Cube User Manual page 34

Network Camera User's Guide
MAC address:
Displays the Ethernet MAC address of the WLAN card. Note that user can not change it.
Site survey:
Click the "Refresh" button. It will refresh information window which list is the result of a
network scan. Access points with a disabled SSID Broadcast will not appear unless the
camera is associated with it. The following information is provided:
Interface Select:
"Wired (Ethernet) only" or "Auto – wired if cable connected, otherwise wireless":
Choose wired or wireless mode. However, note that wired is priority.
Type:
To select one of WLAN modes from Infrastructure or Ad-Hoc mode.
Security mode:
Shows which type of security the network uses. The device supports three security
methods:
None
WEP
WPA_PSK/WPA2_PSK
SSID:
This is the name of the wireless network the device is configured for. The field accepts
up to 32 alphanumeric characters. The name must be exactly the same as that used in
the wireless access point, or the connection will not be established.
Leaving this field blank means the device will attempt to access the nearest open
network.
Channel:
Chooses the wireless channel in use currently.
WEP settings:
- Authentication:
Select Open or Shared Key System Authentication, depending on the
method used by your access point. Not all access points have this option,
in which case they probably use Open System, which is sometimes
known as SSID Authentication.
- WEP Mode:
The key types available depend on the access point being used. The
following options are available:
•ASCII - In this method the string must be exactly 5 characters for 64-bit
WEP and 13 characters for 128-bit WEP.
•HEX - In this method the string must be exactly 10 hexadecimal (0-9, A-F)
characters for 64-bit WEP and 26 hexadecimal characters for 128-bit
WEP.
- Web Key 1~4:
34/96