Page 1
UC-TS003 USER’S MANUAL UNICORN-COMPUTER The UC-TS003 video kit is designed for PC to TV application. It only requires a standard VGA output connector (D-SUB 15PIN, MALE) and 5Volts power (from 2.54 pitch connector, which is the same with the standard 1.44” floppy disk drive’s power connector).
Page 2
UC-TS003 USER’S MANUAL UNICORN-COMPUTER TOP VIEW AND POSITION OF JUMPER AND CONNECTOR: Hard ware installation: Step 1: Connecting the JP7 (D-SUB 15PIN) to motherboard by a cable (D-SUB 15 pin male to D-SUB 15 pin female) of below cable: Note: Picture shown is not a standard length supplied cable.
Page 3
Step 2: Connecting the JP10 by FDD power connector, which the power supply can be AT or ATX. Please note the cable wire of yellow color is near the function key. The UC-TS003 will be damaged when plug the power connector (JP10) by reversed direction.
Page 4
UC-TS003 USER’S MANUAL UNICORN-COMPUTER JUMMPER SETTING: TELEVISION SIGNAL TYPE SETTING (JP2): SIGNAL TYPE NTSC Close Close Close NTSC-EIA Close Open Close PAL-M Close Close Open PAL-N (default) Open Close Close PAL-BDGHI Open Open Close Open Open Open PAL-Combination N Please make sure the television signal type is correct and matching the local television signal type.
Page 5
UC-TS003 USER’S MANUAL UNICORN-COMPUTER POWER SUPPLY TYPE SETTING (JP11): Close 1-2: Power is supplied by the VGA connector’s pin 9. (Not available in all motherboards) Close 2-3: Power is supplied by the standard 4 pin power connector of AT/ATX (JP10).
Page 6
Adjustment of VGA mode and position of television: The position of television will change when VGA mode changed (for example: from 640X480 with 16 bits color to 640X480 with 24 bits color.). UC-TS003 provides the feature to adjust and save position of television by on-board switches.