PROGRAMMING YOUR ST900A
The Built-in Programmes
The built-in programmes give you a starting point that you can personalise to your
own requirements. Your Installer should have selected one and ticked the box
alongside it. If there is no tick, the product normally leaves the factory with Profile A
installed, but it is a simple matter to select one of the other profiles (see Changing
the Installer Parameters, page 12).
Built-in Programme (Profile A)
ON 1
Heating
6:30am
Hot Water
6:30am
Built-in Programme (Profile b)
ON 1
Heating
6:30am
Hot Water
6:30am
Built-in Programme (Profile C)
ON 1
Heating
6:30am
Hot Water
6:30am
Your Personal Programme
The table below has been left blank for you to record your own personal programme.
For ease of use, your ST9400A is supplied as standard with only 2 on/off's enabled. To
enable ON/OFF period 3 see Fine Tuning your ST900A (page 12).
ON 1
Heating
Hot Water
OFF 1
ON 2
8:30am
4:30pm
8:30am
4:30pm
OFF 1
ON 2
9:30am
4:30pm
9:30am
4:30pm
OFF 1
ON 2
7:30am
5:00pm
7:30am
5:00pm
OFF 1
ON 2
OFF 2
ON
10:30pm
Not used
10:30pm
Not used
OFF 2
ON
11:00pm
Not used
11:00pm
Not used
OFF 2
ON
10:00pm
Not used
10:00pm
Not used
OFF 2
ON
OFF
Not used
Not used
OFF
Not used
Not used
OFF
Not used
Not used
OFF