Led Indicators - Virgin MF90C User Manual

Notes
• Adding a memory card is optional
• microSD™ up to 2GB are FAT 16 format.
• microSDHC™ up to 32GB are FAT 32 format.
POWER UP YOUR 4G WI-FI HOTSPOT
Press and hold the Power key for 3-4 seconds until the lights flash.
The LED's flash in sequence to indicate the start up condition. During this
sequence the device functions are not available.
The Wi-Fi hotspot will be available after about 20 seconds.
Note: If you insert the charger with the device off, or the battery is flat, you can
only power up the device after about 20 seconds when the start up sequence is
complete.
Check the condition of your Wi-Fi hotspot as shown by the LED indicators.

LED INDICATORS

On, battery is low (<23%).
Flashing, battery is discharged, (< 12 %).
On, battery is OK (>23 %).
Flashing, battery is charging.
On, WPS is enabled, available for 2 minutes.
Flashing, Wi-Fi is On.
Off, Wi-Fi is off.
Not registered on the network.
No USIM, invalid USIM, PIN or PUK locked.
On, device is registered on 2G/3G,
Flashing, device is connected to 2G/3G.
Device is registered on 4G
Flashing, device is connected to 4G
During periods of inactivity it is normal for the LED's to go out to preserve battery
life. Press the power key briefly to confirm the device status if required.
Page 5 of 36