Available Replacement Parts; Troubleshooting; Replacing A Brush - RugDoctor Mighty Pro Instruction Manual

Available Replacement Parts for Your Machine
Refer to the following diagram if you need to order basic replacement parts for your
machine. Do not use replacement parts other than those available through Rug Doctor.
Do not attempt repairs on a machine under warranty.
1. 92735 Handle Assembly
2. 92030 Dome Assembly
3. 92359D Mighty Pro Recovery Bucket Assembly
92532D Wide Track Recovery Bucket Assembly
4. 10460 Dome Filter
5. 60400 Lower Tank Fill Filter
6. 20091 Screw, #8 X 1/2" (for lower tank Fill Filter)
7. 10461 Lower Tank Sump Filter (not shown)
8. 60719 Mighty Pro Brush Strip
60723 Wide Track Brush Strip
9. 10281 Mighty Pro Wheel
10231 Wide Track Wheel
10. 11183 Wheel Hub Cap

Replacing a Brush

1. Remove the old brush strip from the machine.
2. Align the holes on the new brush strip with the fastening arm holes on the machine.
3. Place a straight edge across the bottom of the wheel and the stainless steel front. Adjust the brush height so that it lightly touches the straight edge.
If the brush extends below the straight edge the machine may bounce when you use it next.
4. Use the screws and nuts from the previous brush to securely attach the new brush strip. Make sure the nuts attach on the brush side that is closest to the
front of the machine.

Troubleshooting

Use this section to help resolve any issues you experience with your machine. If you do not find the answer to your questions here,
please contact the Rug Doctor hotline at 1-800 RUG DOCTOR (1-800-784-3628) or through the Rug Doctor web site at RugDoctor.com.
The Rug Doctor hotline is available 7 days a week (except on legal holidays) from 8 am to 8 pm (CST).
Power Issues
Always use a grounded outlet with this machine. Not doing so can result in electrical shock. Refer to the Grounding Instructions section for
more information.
The machine switch is on, but there is no power.
Try the following steps to resolve this issue:
■
Make sure the electrical cord is plugged in. If the electrical outlet is connected to a wall switch, make sure the wall switch is in
the ON position.
■
Check the circuit breaker switch on the machine and reset if necessary.
■
Check the ALCI plug and reset if necessary.
■
Check the wall circuit breaker. If it is off or if a fuse is blown, unplug the machine and reset the circuit breaker or replace the fuse. Plug the
machine into a different wall plug before beginning again.
■
Check the power cord. If it is defective, please contact the manufacturer or an authorized service agent. An authorized professional must
repair the machine.
The machine switch is on, but there is intermittent power.
Please contact the manufacturer or an authorized service agent. Faulty electrical cable, defective switches, or loose terminal connections
can cause intermittence. An authorized professional must repair the machine.
1
9
10
4
2
3
6
5
8
9