LG HLT35W Owner's Manual page 16

16 Installation
NOTE
• If you operate main unit then wireless subwoofer
(rear speakers) sound within a few seconds in
standby mode.
• Set the distance between this unit and
subwoofer Receiver within 10 m (32 ft.).
• Optimum performance can be implemented
only when the unit and the Wireless subwoofer
within distance of 2 m (6 ft.) to 10 m (32 ft.) is
used since communication failure may occur if
longer distance is used.
• It takes a few seconds (and may take longer)
for the Wireless Transmitter and subwoofer to
3
communicate with each other.
HLT35W-F2_DZAFLLK_ENG_4969.indd 16
2 Connecting
About Ferrite Core (OPTIONAL)
– for EMI only
About Ferrite Core (for EMI only)
You must affix the cores (supplied with the model
you purchased) in order to reduce or eliminate
Be sure to attach the ferrite core to the speaker
electrical interference.
cable. This ferrite core can reduce noises.
How to attach the ferrite core
How to attach the ferrite core
1. Press the stopper [a] of the ferrite core to open.
1. Press the stopper [a] of the ferrite core to open.
2. Wind the cable once on the ferrite core. Attach
2. Wind the power code of the unit
the ferrite core near the unit (Refer to the fig.3
the ferrite core.
and comment.).
3. Close the ferrite core until it clicks.
3. Close the ferrite core until it clicks.
Refer to the fig.3 and comment.
(fig.3)
once on
The length
here is as
short as
possible.
2011-04-14 12:09:11