Section 8 - Servicing - Dixon SKD-2000L/UL/B Operation & Maintenance Manual

SECTION 8 - SERVICING

Maintenance and Inspection:
1. The screwdriver must be operated in peak condition, and the working day
must not exceed more than eight hours.
2. Periodically check for wear of the motor's carbon brushes. If the brushes have
worn down by 2-3mm, replace them with a new brush assembly. Brush life
depends on the operation frequency and torque output. The greater the use and
higher the torque, the more rapidly the brushes will wear. Expect to replace the
brushes every 5-6 months.
3. When the total usage hours reach 1,000 hours or every 5-6 months: (a) clean
the tool's inner parts, (b) replace brushes with new brushes, (c) lubricate the gear
wheel, (d) inspect the cord assembly and armature, and (e) check if the ON/OFF
switch functions normally. This maintenance will extend the tool life and help
maintain torque accuracy.
4. Keep the motor dry and clean. Avoid the carbon build up that may decrease or
destroy the insulation.
5. Every 3-6 months lubricate the gear wheels with the recommended Magnalube
G grease. This will keep the gear assembly running smoothly and decrease the
facing of the clutch.
6. Please note - Do not let the motor get over heated. No more than 10 to 15
screws should be tightened each minute. The duty cycle for the tool is 1:4
(.8 seconds on and 3.2 seconds off).
Page 12 of 14