Section 5 - Bit Changing And Screwdriving Operation - Dixon SKD-2000L/UL/B Operation & Maintenance Manual

SECTION 5 – BIT CHANGING AND SCREWDRIVER
OPERATION
Attaching / Detaching Bits and Types of Bits:
Push the bit holder clamp up with your finger tip, and it will unlock the bit. The bit
can be freely attached and detached (single finger motion type). Select a power
drive hex bit with a shank equal to the size shown below.
Shape of Bit: 6.35mm Hex
Basic Screwdriver Operation:
Insert the power plug into a receptacle and set the direction switch to the forward
"F" position.
For a push-to-start type screwdriver, apply the bit to the screw head and push the
main body against the bit to start the motor running. The motor is turned "OFF"
when the torque level (set by the torque adjustment) is reached or when the
screwdriver is pulled back away from the screw head.
For a lever type screwdriver, apply the bit to the screw head. Then push the lever
to start the motor running. The motor is automatically turned "OFF" when the
torque level (set by the torque adjustment) is reached or when the lever is
released.
To remove a screw, (Dis-Assembly) set the Forward / Reverse switch to the
reverse "R" position, and use the method described above for your type of
screwdriver whether push-to-start or lever type. Note the torque level may need
to be increased to remove a screw once installed at its torque level.
Page 8 of 14