Manual Setup - Linksys X1000 User Manual

Linksys X1000

Manual setup

Set up the wireless network on this screen .
NOTE
After you set up the wireless network(s), set up the wireless security
settings . Go to "Wireless > Wireless Security" on page 14 .
Network Mode
In most network configurations, you should leave it set to
Mixed (default) .
Wireless settings
Basic Wireless Settings (Manual) > Wireless Settings
Network Mode Select the wireless standards your network will support .
Mixed If you have Wireless-N, Wireless-G, and Wireless-B devices in your
•
network, keep the default, Mixed .
Wireless-B/G Only
• If you have both Wireless-B and Wireless-G devices in
your network, select Wireless-B/G Only .
Wireless-B Only If you have only Wireless-B devices, select Wireless-B
•
Only .
Wireless-G Only If you have only Wireless-G devices, select Wireless-G
•
Only .
Wireless-N Only If you have only Wireless-N devices, select Wireless-N
•
Only .
Disabled
• If you have no Wireless-B, Wireless-G, and Wireless-N devices in
your network, select Disabled .
NOTE
If you are not sure which mode to use, keep the default, Mixed .
Network Name (SSID)
The Service Set Identifier (SSID) is the network name
shared by all devices in a wireless network . It is case-sensitive and must not
exceed 32 keyboard characters . The default is Cisco followed by the last 5 digits
of the router's serial number, which is found on the bottom of the router . If
you used the setup software for installation, then the default Network Name is
changed to an easy-to-remember name .
NOTE
If you restore the router's factory default settings (by pressing the
Reset button or using the Administration > Factory Defaults screen),
the Network Name will return to its default value, and all devices
on your wireless network will need to be reconnected .
Channel Width
For best performance in a network using Wireless-B, Wireless-G
and Wireless-N devices, select Auto (20 MHz or 40 MHz) . For a channel width
of 20 MHz, keep the default, 20 MHz only .
Standard Channel Select the channel from the drop-down list for Wireless-B,
Wireless-G, and Wireless-N networking . If you are not sure which channel to
select, then keep the default, Auto .
SSID Broadcast When wireless clients survey the local area for wireless
networks to associate with, they will detect the SSID broadcast by the router .
To broadcast the router's SSID, keep the default, Enabled . If you do not want to
broadcast the router's SSID, then select Disabled .
Advanced Configuration
12