Toshiba Satellite Maintenance Manual page 103

2Troubleshooting Procedures
The operation or system board may be the reason of 3D sensor fault. Either of these two may
be damaged. To determine if the computer's 3D is functioning properly, perform the
following procedures. Figure 2-24 outlines the process. Start with Procedure 1 and continue
with the other procedures as instructed.
Procedure 1: Diagnostic test
Procedure 2: Replacement check
Procedure 1 Diagnostic test
Run the functioning Program on Windows model, which will display the 3D test result.
If tests and diagnostics result abnormal go to Procedure 2. If an error is not located, the 3D
functioning is properly.
Procedure 2 Replacement check
Disassemble the computer following the steps described in Chapter 4, Replacement
Procedures, and perform the following checks.
Check 1 Make sure that 3D sensor test operation is correct, go to Check 2.
Check 2 The system board may be damaged. Replace it with a new one following the
instructions in Chapter 4.
SatelliteA660/ProA660 Series Maintenance Manual
69
Figure 2-24 3D sensor troubleshooting process