Usage; Oven Signal; Oven Operation; Oven Light - Amana RSBG669T Use And Care Manual

Usage

Oven Signal

Oven features an entry signal and end-of-cycle
signal programmed at factory. Signal can be
deactivated. Entry signal sounds whenever a pad is
pressed. It confirms oven has read and accepted
instruction. End-of-cycle signal sounds at end of
cooking time.
To cancel entry signal or end-of-cycle signal
1. Press and hold MEMORY SET for five seconds.
"OP:10" or "OP:11" displays. See chart at right
for definition of signal options.
2. To change signal option, press 0 to deactivate
entry signal. Press 1 to activate entry signal.
3. Press MEMORY SET. "OP:20" or "OP:21"
displays. Change signal option for end-of-
cycle signal, if desired.
4. Advance to next signal option by pressing
MEMORY SET.
5. To exit signal option mode, press STOP/RESET
once.

Oven Operation

A. Oven light comes on when door is opened
and also when oven is operating.
®
B. Rotawave System beams microwave energy
directly to food in uniform pattern for even
cooking results.
•
C. Turntable will randomly rotate clockwise or
counter-clockwise, determined by turntable
stop position.
•
When defrosting or cooking (especially large
items, such as poultry), verify turntable rotates
freely.
D. Set the Clock
1. Press CLOCK. "CLOCK" displays.
2. Enter time of day. For example, 10:35 (a.m.
or p.m.) press number pads 1,0,3,5.
3. Press CLOCK again. Clock is set. If oven
power is interrupted all programming
instructions erase. When power is
reconnected, dashes appear in display.
Reset clock as indicated above.
Option Option Function
Number
OP:10 Prevents signal from sounding when a
pad is pressed.
OP:11* Allows signal to sound when a pad is
pressed.
OP:20 Prevents end-of-cycle signal from
sounding when heating time is over.
OP:21* Allows signal to sound at end of
heating time and timer cycle.
*As shipped from factory.
E. Check operations of interlock systems. The
START and STOP/RESET pads turn oven on
and off. Microwave energy is generated only
when door is closed, cooking time is set, and
START is pressed. In addition, oven has
interlock switches to assure no microwave
energy is generated when door is open. To
check or remove food before cooking time is
elapsed, either press STOP/RESET or open
oven door to turn oven off.
To check operation of START, STOP/RESET and
interlock switches:
1. Place a glass of water in oven. Close
door.
2. Press TIME ENTRY.
3. Press 5,0 (50 seconds).
4. Press START. Oven should operate and
oven light should come on.
5. Press STOP/RESET. Oven and oven
light should shut off immediately.
6. Open oven door fully. Oven light should
come on when door is opened.
7. Press STOP/RESET.
If under any of the preceding conditions oven does
not operate as stated, do not use it. See "Factory
Service Centers" section on back page.
8