Advertisement
ZUMA BREWER - OPERATION & SERVICE MANUAL
Installing the Screen Assembly
1. Line up the screen assembly in the recession on top of the brewer cylinder. Make certain that
the bump on one of the sides of the screen assembly is pointing to the rear of the brewer
cylinder.
NOTE:
The screen has to be inserted in a particular way. There are clips on each end of the
screen assembly. These clips must be pointing downwards, and to the right and left sides
of the cylinder. If they do not, the screen assembly cannot be locked in place.
2. With the clips properly lined up, push down on the screen assembly until it locks in place.
3. Re-install the brew chamber in the brewer. Make certain that the wiper assembly is inserted
between the two stainless steel arms at the rear of the brewer.
4. Re-install the brewer into the machine.
Page 6 of 8
Bump Goes Towards the
Rear of the Cylinder
Clips on Sides of
Screen Assembly
Zuma Brewer Screen Assembly
0011
Zuma Brewer (N016352)
Advertisement
