Mounting To A Rack - JVC LST0601-001B Startup Manual

Getting Started
Part Names and Functions
(continued)
Rear I/O Terminals
Terminal
e[ALARM
IN]
250 ms
and above
Make
Memo :
● Set the impedance at the output
end to 10kK or below.
f[EMER-
GENCY]
g[ALARM
RESET]
250 ms
and above
Memo :
● Set the impedance at the output
end to 10kK or below.
h[EXT REC
IN]
250 ms
and above
Memo :
● Set the impedance at the output
end to 10kK or below.
j[OPE ON/
OFF]
1 s and
above
OPE ON
Memo :
● Set the impedance at the output
end to 10kK or below.
j[REC
TALLY]
k[ALARM
Make
OUT]
Output In
l[WARN-
Progress
ING OUT]
m[OPTION
OUT1] (External Pull-up Level)
[OPTION
The make contact is formed using
OUT2]
the individual output terminals and
the COM terminal. Turning off the
power of VR-N1600U/E switches the
output of the output terminals to
break.
10
Remarks
Make
Contact
250 ms
Input
and above
Break
Make
Contact
Input
Make
Contact
Input
Make
Contact
Input
Approx. 50 ms
OPE OFF
Auto
Break
Collector
Output In Output
(DC15V, 10
Progress
mA and
below)

Mounting to a Rack

Use the supplied rack mount bracket to mount VR-N1600U/E
to the EIA rack.
1
Mount the rack mount bracket using screw (1)
● Use the 4 screws (M4 x 10 mm) supplied to fasten
VR-N1600U/E at the two sides.
2
Remove screws B of the foot (4 pcs) at the
bottom
● Remove the foot.
3
Mount to the rack using screws C
● Use the 4 screws (M5 x 11 mm) supplied to fasten this
unit to the rack.
Rack Mount
Bracket
Note :
● Do not place any object on the VR-N1600U/E unit that
has been mounted to the rack. Doing so may cause it to
lose balance and drop or fall, hence resulting in injuries or
damages.
● When mounting 2 or more units of VR-N1600U/E to the
rack, make sure to mount it at a distance that is at least
equivalent to one unit.
(4 Locations)