Download Print this page

Inteno X5669 Installation Manual page 3

Adsl2+ residential gateway

Advertisement

Available languages

Available languages

X5669 ADSL2+
Residential Gateway
Back
Front
X5669 ADSL2+
4
Residential Gateway
This installation guide will help you install the Inteno X5669
a
ADSL2+ Residential Gateway. Your service provider will supply
you with information about log in and access.
Start Box
b
Check that the following items
are in the Start Box:
• Inteno X5669 Residential Gateway
• Power adapter
• LAN Network cable (yellow)
(large contact)
• Telephone cable (small contact)
AR382
• Extension adapter (splitter) with
built-in DSL filter
• Bracket (for upright mounting)
Connecting the DSL
c
Do as follows:
1. Shut down your computer.
2. Connect the telephone extension
adapter to the first telephone jack
inside the house.
3. Connect the telephone cable between
the telephone extension adapter where
it is marked ADSL and the X5669
DSL-port (DSL).
Connecting the LAN
d
1. Connect the yellow network cable
between the X5669 network port
(LAN 1-4) and the network port on the
back or side of your computer.
NOTE! In some cases, your broadband
supplier will instruct you to connect to
a specific network port (LAN 1-4).
Verify this in the documents and/or
manual you received from your service
provider.
2. Finally, plug the power adapter into
an electrical outlet and contact into the
modern where it is labelled "Power."
3. Start the computer.
4. The colored lights will blink for roughly
30 seconds. If you have connected
your modem properly, the Power, WAN
and Internet lights will be a fixed green
color. See picture labelled "Front." You
have now connected the X5669.
X5669 ADSL2+
Residential Gateway
5

Advertisement

loading