Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Mobi-click compact
Summary of Contents for Mobi-click compact
- Page 1 COMPACT User manual www.mobi-click.com...
-
Page 2: Table Of Contents
Whether everything is set correctly? Test! Baby phone: What is the meaning of the SMS messages? As a Baby phone Mobi-Click alarms you immediately if your child is crying or climbing out of Eavesdrop in? Yes, but pay attention...! bed. -
Page 3: Important Information
OFF to the ON position. Leave the Compact connected to the battery charger for a minimum of 40 Minutes to ensure that the battery is fully charged. -
Page 4: At First: Change The Pin-Code
At first: change the PIN-code! Put the new SIM-card into the As Mobi-Click Compact has only 3 buttons and a ON/OFF power button some settings have to be done on a second "normal" Place SIM-card with the changed "normal" mobile phone mobile phone at the first use. -
Page 5: Switch On/ Off Mobi-Click Compact
(the yellow and the green LED Ready for use Should the green LED not start flashing, turn off the Mobi-Click using the ON/OFF-button and check to ensure the SIM-card has been inserted correctly. Also ensure that you are in a good will flash during this operation). -
Page 6: Mobile Phone, Emergency And Alarm System At The Same Time
Multifunctions Mobile phone, emergency and alarm system at the same time! Activate as mobile phone Activate as emergency system Activate as alarm system Activate test mode Press the two Press when switching Keep the two Press the two buttons when on (power ON/OFF). -
Page 7: How Do I Save The 3 Phone Numbers
You can store all three numbers at one time by sending the instruction set key Next number: followed by the three numbers you wish to send to the Mobi-Click Compact. This acts the same as the instruction for only one number (e.g. set TEL/SMS1). (Note! The continue with Set TEL3 +4152765... -
Page 8: My First Phone Call With Mobi-Click Compact
Start My first phone call with Mobi-Click Compact Keypad lock Activate as mobile phone If it‘s ringing... (RED) Reject call KEYPAD LOCK: (see also page 10) Switch on Mobi-Click: Press ON/OFF- button, until you hear the dual tone. Wait Dial the number... -
Page 9: Switch On The Alarm Standby With Another Mobile Phone
Protection against burglary SMS messages on your mobile phone, then you Motion-sensor activated. Set home are also able to serve Mobi-Click. All settings of e.g.: set baby: Baby phone Mobi-Click are made by a simple principle: Motion- and acoustic- sensor/ Write a SMS on your mobile phone. -
Page 10: What Should I Do In Case Of An Alarm
ALL the numbers that you saved ALL the numbers that you was released! wish Mobi-Click to alarm in event of an alarm You receive a short AREA : off Which persons were be alarmed? (see page 12-13) -
Page 11: How Will I Be Informed Per Sms In Case Of An Alarm
The notify process can be interrupted only by (repeat process) Number 2 will be deactivated. If you use Mobi-Click Compact as a mobile phone you can pressing any button on Mobi-Click Compact. dial these three numbers directly with the three coloured... -
Page 12: Mobi-Click For The Car
Start Activate the alarm system as described above. Mobi-Click Compact is now ready. To activate car monitoring function press the red button. Now the countdown starts automatically (peep…peep…). Quickly hide Mobi-Click Compact in your car and leave. -
Page 13: Mobi-Click At Home
Start Right placement Activate the alarm system as described above. Mobi-Click Compact is now ready. To activate the alarm function in home- mode press the green button. Now the countdown starts automatically (peep…peep…). Quickly hide Mobi-Click Compact in the room and leave. After 15 seconds Mobi-Click is ready. -
Page 14: Mobi-Click In The Child's Room
"set baby call" from your mobile phone to Mobi-Click. Mobi-Click will be The Mobi-Click baby sensor is set to MID as default. This can be adjusted by setting the sensitivity to LOW, MID or HIGH switched on and calls you back immediately for confirmation. With the instruction when you send the Set Baby command. -
Page 15: How Do I Choose The Right Alarm Instruction
Motion-sensor (PIR): Registers every move within a distance of about 5 meters. Set Move Put your Mobi-Click with the sensor in direction of the corridor or the door but never in direction of the window. Voice Move... -
Page 16: Whether Everything Is Set Correctly? Test
SMS and telephone alarm numbers Confirmation of the instruction: 31.03.2004 10:11 Date / time 31.03.2004 10:11 Date / time COMPACT 42 Name and software version HOLIDAY HOUSE changed name List of saved System and mobile Practice alarm. Mobi-Click calls all... -
Page 17: Eavesdrop In? Yes, But Pay Attention
Tel2 Mobi-Click calls back the pre-programmed telephone alarm number 2 It is possible to do a general reset to factory default settings when you start the Mobi-Click Compact in alarm mode (see page 11). This will also reset the PIN-Code. -
Page 18: Can I Write Personal Alarm Messages
For every sensor can be assigned a personal text which is allowed to consist of 21 signs. Personal texts are used to describe an alarm which had happen more exactly, especially if the alarm message goes See the following samples: to a third person or if there are several Mobi-Click devices in order. voice text... -
Page 19: How Can I Test If The Text Is Correct
This instruction can be deactivated simply with the instruction "Reset Email". In order to determine whether the e-mail address of the receiver was stored correctly, you send the instruction "Test Text" to Mobi-Click, and you receive a reply, in which the stored e-mail address is indicated. -
Page 20: Security Zone And Localization Of Persons Or Objects
LOW. If there is a connection, then this stand-by level will logically be pulled up to HIGH. Therewith Mobi-Click Compact recognises with the next set function (SET XXX) or with the next mode shift (SET ALARM) a standby power Learning mode is activated. -
Page 21: Technical Data
Basic Standard for the measurement of Specific Absorption Rate related to Human Exposure to Electromagnetic Fields from Mobile Phones Mobi-Click is designed to the following standards: GSM 03.03: “Digital cellular telecommunications system (Phase 2+); numbering, adressing and indentification“. Version 6.6.0. - Page 22 Temperature range: working range –10°C to +55°C storage range –25°C to +80°C You can also connect external sensors to Mobi-Click. The connected sensor must operate with standards NO or NC. You can Weight: 78g (including battery) connect as well simple short/open detectors. The defined mode allows you to choice type of the external equipment between normally opened and normally closed.
Need help?
Do you have a question about the compact and is the answer not in the manual?
Questions and answers