JVC HR-XVC33UM Instructions Manual page 87

Filename [XVC33UM_11Trouble.fm]
XVC33UM_01.book Page 87 Monday, August 4, 2003 7:24 PM
OTHER PROBLEMS
SYMPTOM
1. The image of TV broadcast appears
distorted on the TV screen.
2. Whistling or howling is heard from the
TV during camcorder recording.
3. When scanning channels, some of
them are skipped over.
4. The channel cannot be changed.
5. Channel settings that were made
manually seem to have changed or
disappeared.
ATTENTION
This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the
unit off and unplug the AC power cord. Then plug it in again and turn the unit on. Take out the cassette. After checking the cassette,
operate the unit as usual.
Page 87
POSSIBLE CAUSE
The unit leaves turned on and the DVD
deck is selected.
The camcorder's microphone is too
close to the TV.
The TV's volume is too high.
Those channels have been designated to
be skipped.
Recording is in progress.
After the manual settings were made,
Auto Channel Set was performed.
Masterpage:Right-No-Heading
EN
CORRECTIVE ACTION
Turn off the unit, or press VCR to select the
VCR deck, then press TV/VCR so that the
VCR indicator disappears from the front
display panel.
Position the camcorder so its microphone
is away from the TV.
Turn the TV's volume down.
If you need the skipped channels, restore
them. ( pg. 27)
Press PAUSE (9) to pause the recording,
change channels, then press PLAY (4) to
resume recording.
Perform manual setting again.
4 August 2003 6:50 pm
87