Advertisement
Diagram A
Diagram B
Diagram C
Mounting the DoorGuard Sensors:
The DoorGuard sensor will detect a tilting or swinging motion of any type of
door. These sensors are typically mounted on main cabin entry doors, cargo
bay doors along with any type of compartment door that has a hinge
movement which tilts or swings open and closed.
1.
Carefully remove the 6 screws, top cover plate and seal to the sensor.
Now the battery compartment and circuit board is exposed (Diagram A).
2.
First, locate and mark the sensor mounting position on the inside of
each door. Make sure that each door will open and close properly before you
mark its position. Use a marker pen to place a dot in the middle of each
mounting tab hole. This is where you will use #6‐ ¾ " Flat head self tapping
screws to mount securely (Diagram B). You may also use high‐ strength double
sided tape to mount. Make sure both surfaces are cleaned with an alcohol
based cleaner to ensure the contact points are free from dirt and oils. Peel the
plastic backing off to expose the tape adhesive and apply to the sensor, hold
firmly for 20 seconds. Then peel the remaining plastic backing off and using
both hands place in the desired mounting location and press firmly for 20
seconds ensure proper bond.
3.
Install batteries (Diagram C)
4.
Re install rubber seal, cover and screws. Installation is complete.
5.
Refer to the Owner's Manual for pairing and programming sensors.
3
Advertisement
