Samsung TX20C53X/XET Service Manual page 13

4-2-15 Holder Clutch Ass'y Removal
1) Remove the Washer Slit Œ.
2) Lift the Holder Clutch Ass'y ´.
Note : When you reinstall Holder Clutch Ass'y
1) Check the condition of spring as shown in detail A.
2) Don't push Holder Clutch Ass'y down with exces-
sive force Just insert Holder Clutch Ass'y into post
center with dead force and Rotate it smoothly.
Be sure to confirm that spring is in the slit of Gear
Center Ass'y as shown in detail B.
<BAD>
<BAD>
Fig. 4-20 Holder Clutch Ass'y Removal
Samsung Electronics
ΠWASHER SLIT
´ HOLDER CLUTCH ASS`Y
DETAIL A
SPRING
<GOOD>
DETAIL B
SPRING
<GOOD>
4-2-16 Lever Up Down Ass'y, Gear Center
Ass'y Removal
1) Remove the 2 hooks in the direction of arrow as
shown Fig. 4-21 and lift the Lever Up Down Ass'y Œ.
2) Lift the Gear Center Ass'y ´.
Assembly :
1) Insert the Lever Up Down Ass'y Πin the rectan-
gular holes on Main Base as shown in Fig 4-22.
2) Lift the Lever Up Down Ass'y Œ about 35°.
(Refer to Fig 4-22)
3) Insert Ring of the Gear Center Ass'y ´ in the
Guide of the Lever Up Down Ass'y Œ.
4) Insert the Gear Center Ass'y ´ in the post on
Main Base.
5) Push down the Lever Up Down Ass'y Πfor
locking of the Hook.
Note :
1) Take care not to separate and sentence does not
mark sense.
2) Be sure to confirm that Ring of the Gear Center
Ass'y ´ is in the Guide of the Lever Up Down
Ass'y Πafter finishing assembly of Lever Up
Down Ass'y Œ and Gear Center Ass'y ´.
Fig. 4-21 Lever Up Down Ass'y Removal
GEAR CENTER ASS'Y
RING
GEAR
POST
HOOK
Fig. 4-22 Lever Up Down Ass'y Removal
Disassembly and Reassembly
ΠLEVER UP DOWN ASS`Y
´ GEAR CENTER ASS`Y
GUIDE
LEVER UP DOWN ASS'Y
35
MAIN BASE
4-11