Figure 2: Battery Compartment Layout - OTS DRS-100 Mod B User Manual

11. Connect the other end of the battery jumper to the red terminal of the other
battery.
12. Connect one end of the interconnection cable (Fig. 2, #18) to the remaining
black and red terminals.
13. Reconnect J8, J10, J11, J12, and J13 to the circuit board assembly. J10, J11,
J12, and J13 are labeled and should be connected to the corresponding plugs
on the circuit board (P10, P11, etc.). J8 is probably not labeled but is the one
remaining connector of the wiring harness that attaches to the circuit board;
it should be connected to P8.
14. Check the o-ring (Fig. 2, #21) on the inside of the housing for debris or dam-
age. Replace it if necessary.
15. Reinstall the front panel and the ten front-panel screws (just tightly enough to
make a good seal).
16. Fully charge the batteries (Section 3.1, p. 7).
18. Battery interconnection cable
19. Battery jumper
20. Housing
21. Housing o-ring
Figure 2. Battery Compartment Layout
22. Hex nut, #8-32 (battery bracket mounting)
23. Battery bracket
24. Battery
Key
9