Advertisement
OPERATION INSTURCTIONS:
1. When the power wheelchair is in operation, please make sure fasten the controller pin as shown in figure 1.
2. When the controller pin is pulled out (shown in figure 2), the controller can be retracted horizontally (shown in figure 3)
and please do not drive the wheelchair for your own safety.
3. To recharge the batteries, please turn off the power first and plug the charger power cord underneath the controller (shown
in figure 4).
4. When the battery is charging, the yellow LED will illuminate. When charging is completed, the yellow LED will turn
green (shown in figure 5).
5. When travel abroad, do not use for voltage input unless specified. Make sure your present voltage input (115V or 235V)
and adjust manually (shown in figure 6) to prevent battery damage.
6. For maximum performance, it is recommended that recharge the Li-Ion Battery periodically or every time after you finish
using the wheelchair to prevent battery damage.
7. If the power failure occurs accidentally, please wait for 30 seconds and turn on the power again for operation.
figure 5
Figure 1
Figure 3
figure 6
Figure 2
Figure 4
Advertisement
