Bang & Olufsen BeoVision 7 User Manual page 14

>> Connections
Connect and use a PC
IMPORTANT! Before connecting a PC to
the television, disconnect the television,
the computer, and all equipment
connected to the computer from the
mains.
To connect a computer to the
television ...
> Using the appropriate type of cable,
connect one end to the DVI, VGA or HDMI
output socket on your computer, and the
other end to the VGA or HDMI socket on
the television.
> To hear sound from the computer in the
speakers connected to the television, use
the appropriate cable and connect the
sound output on the computer to the L–R
or SPDIF sockets on the television when
appropriate.
> Reconnect the television, the computer,
and all equipment connected to the
computer to the mains. Remember, the
computer must be connected to a
grounded wall outlet as specified in its
setting-up instructions.
If you have connected your PC to the VGA
socket on the television, you must register
the PC to the AV5 or AV6 socket in the
CONNECTIONS menu. A PC connected to
the HDMI socket can be registered to any of
the AV socket groups.
14
Bring up the computer image on the
screen
To see the computer picture on the screen,
you must bring it up with your remote control.
To bring up the computer picture ...
> Press PC to bring up the picture. You can
then operate the computer as you
normally would. (Beo4: Press LIST and use
the navigation button up or down to bring
up PC in the Beo4 display and press the
centre button to bring up the picture).
Watch digital pictures on your screen
To watch your camera pictures, connect the
camera to the AV6 socket(s) and switch the
television on. The television automatically
registers the signal and you can see the
pictures on the screen.
If the signal from the camera is switched
off ...
> Press CAMERA on Beo6. (Beo4: Press LIST
and use the navigation button up or down
to bring up CAMERA in the Beo4 display
and press the centre button to bring up
the picture).